Urology Plasma Surgery System for BPH Treatment

Urology Plasma Surgery System for BPH Treatment

Product Introduction

This PLA-600 Model Urology Plasma Surgery System are designed to appliy into the field of urology. On the front panel, there are two working modes, Ablation mode and Coagulation mode. Which can be adjust from 1 to 10 level by push the plus + or reduce - button. It is widely applying to BPH and Bladder tumor treatment.

Product Diagram

Technical Parameter

Product Advanatages

• Safety: multi-polar design, change the traditional way that current flow through human body
• Low Temperature: 40 to 70 centigrade during operation, decrease the thermal damage to around normal tissue
• Precise cutting: the thin plasma layer make precise cutting becoming true, and it will not hurt the around normal tissue
• Speedy cutting: cutting and coagulation at the same time, no need to change the probe frequently, saving operation time
• Shorten recovery period: less hurt to human body, recovery faster

System Set Up

System Component

1). One tabletop generator device

2). One reusable and non-sterile power supply cable.

3). One reusable and non-sterile footswitch.

4). One reusable and non-sterile treatment handle which is for foot control.

5). Treatment probes.

Storage Condition

This device should be stored in a well-ventilated room without corrosive gas. The height above ground and the distance from wall should be above 30cm. Stack limit is 6 cases. Before being stored for a long time, it should be cleaned thoroughly for proper packing and storage. And it should also be taken out for power up every year, in order to avoid it from moisture, mildew or even damage. The suitable weather and environment condition is as below:

1. Temperature: -40℃～+55℃;

2. Relative humidity: ≤90％;

3. Atmospheric pressure: 50kPa～106kPa